The expert warned about the danger of worn brake pads
Even a slight decrease in braking performance on slippery surfaces can lead to loss of control over the vehicle. Andrey Babushkin, technical director of LYNXauto, warned about this on November 17 in a conversation with Izvestia.
He noted that the minimum allowable thickness of the friction lining of the brake pad is 2-2.5 mm, however, it is strongly discouraged to delay the replacement to this limit.
"We must take into account that there is uneven wear, and the inner shoe, as a rule, wears out more. When the driver independently evaluates the residual thickness of the friction lining, he usually looks at the outer pad. Its thickness can be much greater than that of the inner one. Therefore, with a residue of 3-4 mm, it is already necessary to replace it," explained Andrey Babushkin.
The main danger of critically worn pads is the complete erasure of the friction layer, the expert explained. At this point, braking occurs due to the "steel on cast iron" friction pair, where the coefficient of friction is critically low. In addition, with severe wear, the piston of the brake cylinder reaches its maximum value, which leads to the risk of its skewing and jamming.
Uniform wear of the friction linings with fully functional mechanisms should not disrupt the operation of the anti-lock braking system (ABS) and stability control systems, said Andrey Babushkin. However, if there are already mechanical malfunctions in the system — a difficult running of the caliper, a curvature or jamming of the guides — the active safety systems will not be able to work correctly even when completely new pads are installed.
Oleg Markov, a technical expert at Cordiant Holding, told Izvestia on October 27 that retrofitting tires that were already in use is a technology not provided for by tire manufacturers, but in practice there are situations when such repairs can slightly extend the life cycle of a tire. The maximum permissible residual depth of the tread pattern is 4 mm. Accordingly, in order for the tire to have a residual life before the retrofitting process, its tread height must be at least 6 mm.
Переведено сервисом «Яндекс Переводчик»